Heat.net

Heat.net Store Home


DC Water Heater Element 12 Volt 300 Watt with Thermostat 140 Degrees F For Sale


DC Water Heater Element 12 Volt 300 Watt with Thermostat 140 Degrees F
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Buy Now

DC Water Heater Element 12 Volt 300 Watt with Thermostat 140 Degrees F:
$34.19

See our video on our high efficiency water heating elements and run video on our new LifePo 4 Bettery
DC Water Heater Element 12 Volt 300 Watt with Thermostat 140Degrees F

ONE 7 INCH DC WATER HEATING ELEMENT 12 VOLT 300 WATT 

with automatic resetting thermostat for DC water heating 140 Degree Fahrenheit 

Fits standard water heaters with a 1" NPT

 

First we start with solid brass base and copper

Then it gets nickel plated for long water tank deicer (low amp draw means you won't drain your battery as fast)

  • For keeping dog, cat, and other domestic animals water from freezing 
  • Standard American water heater element replacement
  • Water preheating
  • Campers, Motor homes
  • Emergency hot water 
  • Portable commercial, industrial machines and equipment
  • Runs off your car battery for portable hot water anywhere
  • Direct wind and solar applications 
  • Concrete mixing trucks
  • and many, many more uses where heat or diversion loads are needed
  • DC water heating elements are much safer than 110 volt

     

    WIND TURBINE WATER HEATING

    Heat water directly using a wind turbine generator (with or without a battery bank). Wind turbine generators are used primarily for electricity generation. The power used can be stored in a battery bank or connected to the mains supply using a suitable grid tie inverter.
    In very strong winds, and/or when the batteries are fully charged a wind turbine may generate more current than the batteries can handle.

    Therefore a dump load is often used to divert the extra energy to heat water so it is not wasted and so that the wind turbine does not spin so quickly that it is damaged.
    Diversion Load Water Heating

    Pictured above is a typical 12V water heating element which can be
    screwed into an immersion heater drain-cock hole.
    When used as a diversion (dump) load, such an element is connected to the batteries via a charge regulator.
    When the regulator detects that the batteries are fully charged, it diverts the generated electricity to the element which heats water.

  • Hurricane Wind Power
    2019Corporate America Today2019 Best Off-Grid Renewable Energy Product Supplier - USAUP TO 50% DISCOUNTSTOP accept payment by any of the following pay as soon as possible after winning an sale, as that will allow us to post your item to you sooner!


    We offer Fast shipping on all orders!


    Your order will be dispatched within 1-3 working day of receiving payment (Monday-Friday) and you should expect to receive it one or two days after dispatch (for orders sent RM 1st Class).


    In the very unlikely event that your item is lost or damaged during post, then WE are responsible and will issue either a full refund or replacement.

     

    If you are not 100% satisfied with your purchase, you can return the product and get a full refund or exchange the product for another one, be it similar or not.

     

    You can return a product for up to 14 days from the date you purchased it.

    Any product you return must be in the same condition you received it and in the original packaging. Please keep the receipt.

    ONE 7 INCH DC WATER HEATING ELEMENT 12 VOLT 300 WATT 

    with automatic resetting thermostat for DC water heating 140 Degree Fahrenheit 

    Fits standard water heaters with a 1" NPT

     

    First we start with solid brass base and copper

    Then it gets nickel plated for long water tank deicer (low amp draw means you won't drain your battery as fast)

  • For keeping dog, cat, and other domestic animals water from freezing 
  • Standard American water heater element replacement
  • Water preheating
  • Campers, Motor homes
  • Emergency hot water 
  • Portable commercial, industrial machines and equipment
  • Runs off your car battery for portable hot water anywhere
  • Direct wind and solar applications 
  • Concrete mixing trucks
  • and many, many more uses where heat or diversion loads are needed
  • DC water heating elements are much safer than 110 volt

     

    WIND TURBINE WATER HEATING

    Heat water directly using a wind turbine generator (with or without a battery bank). Wind turbine generators are used primarily for electricity generation. The power used can be stored in a battery bank or connected to the mains supply using a suitable grid tie inverter.
    In very strong winds, and/or when the batteries are fully charged a wind turbine may generate more current than the batteries can handle.

    Therefore a dump load is often used to divert the extra energy to heat water so it is not wasted and so that the wind turbine does not spin so quickly that it is damaged.
    Diversion Load Water Heating

    Pictured above is a typical 12V water heating element which can be
    screwed into an immersion heater drain-cock hole.
    When used as a diversion (dump) load, such an element is connected to the batteries via a charge regulator.
    When the regulator detects that the batteries are fully charged, it diverts the generated electricity to the element which heats water.

  • Hurricane Wind Power
    2019Corporate America Today2019 Best Off-Grid Renewable Energy Product Supplier - USAUP TO 50% DISCOUNTSTOP BRANDSPayment

     

    We accept payment by any of the following pay as soon as possible after winning an sale, as that will allow us to post your item to you sooner!

    Shipping


    We offer Fast shipping on all orders!


    Your order will be dispatched within 1-3 working day of receiving payment (Monday-Friday) and you should expect to receive it one or two days after dispatch (for orders sent RM 1st Class).


    In the very unlikely event that your item is lost or damaged during post, then WE are responsible and will issue either a full refund or replacement.

    Returns

     

    If you are not 100% satisfied with your purchase, you can return the product and get a full refund or exchange the product for another one, be it similar or not.

     

    You can return a product for up to 14 days from the date you purchased it.

    Any product you return must be in the same condition you received it and in the original packaging. Please keep the receipt.

    ONE 7 INCH DC WATER HEATING ELEMENT 12 VOLT 300 WATT 

    with automatic resetting thermostat for DC water heating 140 Degree Fahrenheit 

    Fits standard water heaters with a 1" NPT

     

    First we start with solid brass base and copper

    Then it gets nickel plated for long water tank deicer (low amp draw means you won't drain your battery as fast)

  • For keeping dog, cat, and other domestic animals water from freezing 
  • Standard American water heater element replacement
  • Water preheating
  • Campers, Motor homes
  • Emergency hot water 
  • Portable commercial, industrial machines and equipment
  • Runs off your car battery for portable hot water anywhere
  • Direct wind and solar applications 
  • Concrete mixing trucks
  • and many, many more uses where heat or diversion loads are needed
  • DC water heating elements are much safer than 110 volt

     

    WIND TURBINE WATER HEATING

    Heat water directly using a wind turbine generator (with or without a battery bank). Wind turbine generators are used primarily for electricity generation. The power used can be stored in a battery bank or connected to the mains supply using a suitable grid tie inverter.
    In very strong winds, and/or when the batteries are fully charged a wind turbine may generate more current than the batteries can handle.

    Therefore a dump load is often used to divert the extra energy to heat water so it is not wasted and so that the wind turbine does not spin so quickly that it is damaged.
    Diversion Load Water Heating

    Pictured above is a typical 12V water heating element which can be
    screwed into an immersion heater drain-cock hole.
    When used as a diversion (dump) load, such an element is connected to the batteries via a charge regulator.
    When the regulator detects that the batteries are fully charged, it diverts the generated electricity to the element which heats water.


  • Buy Now

    Other Related Items:



    Related Items:

    3

    3" DC 24V Solar Water Pump Deep Well Pump Submersible Bore MPPT Controller Kit

    $189.99



    Aquarium 24V DC Water Pump with Controller , Submersible and Inline Return Pump  picture

    Aquarium 24V DC Water Pump with Controller , Submersible and Inline Return Pump

    $99.99



    DC 12V 2GPM Diaphragm Water Pump Self Priming 130PSI RV Camper Marine Boat Lawn picture

    DC 12V 2GPM Diaphragm Water Pump Self Priming 130PSI RV Camper Marine Boat Lawn

    $31.99