DRASH indirect fuel fired heater For Sale

Used Mil Spec Ruggedized Diesel Heater.  Heater comes with 2 15\' duct sections in carrying cases.  Users technical and maintenance manual can be downloaded from the company website.  Local Pick Up in  Edmond Oklahoma preferred, but will assist buyer in arranging fright shipping.  Heater is already palletized and ready to go.  Original retail price of this heater was $5300.  All serious offers will be considered.The D-1000B Heater is rugged, lightweight, rust resistant, shock proof and easy to operate and maintain, providing nearly 112,000 BTUs/hr of dry, clean heat at a rate of 1,020 CFMs. The heater includes an electronic control system that monitors for high heat conditions and flameout, and operates on an external input of 120 VAC, 60 Hz, single-phase power. It includes full safety protection devices, including a safety shut off switch that shuts off upon detecting 100 ppms of Carbon Monoxide content. Its pre-heated fuel filter allows the heater to work continuously in extreme low temperatures, and it can run for 12 consecutive hours without refilling the fuel tank.FEATURES:Compact and mobile, indirect fuel fired air heaterCSA B140.0-03 & B140.8-1967 Certified, UL 733 CompliantHeated air is separated and independent from combusted airAdjustable fresh air make-up inlet window constantly delivers fresh air with oxygen to the tentPre-heated fuel filter allows heater to work at extreme low temperaturesEstimated efficiency: approximately 87 percentStainless steel combustion chamberRugged, two piece molded polyethylene outer body (lower and upper) Control Panel designed to operate in environmental extremesOperates up to 12 hours continuously without fuel refillAccurate solid-state remote thermostat controlRemote CO (carbon monoxide) detector and automatic shut offCan operate remote control (Thermostat & CO sensor combo unit) inside of tent, extra comfort and safety built-in features throughout system12 in x 15 ft flexible duct sections (supply and return)- High temperature gradeVisual fuel gaugeFabric duct end coversHeaters are stackable for maximum storage efficiencyDesigned for simple field maneuverability (wheel-able and equipped with snow slide)Designed with handles for easy four man liftCan operate at temperatures as low as heat exchangerHeat Input Capacity: 112,000 BTUs/hrAir Flow: 1,020 cfmFuel Consumption: 0.8 gal/hrNozzle: 0.55 - 80°WPump Pressure: 196 psiFuel Tank Capacity: 10.8 galPower Supply: Single Phase, 120VAC @ 5.8 Amps, 60 HzPower Consumption: 440WFuse: 20AFlue Diameter: 5.9 in.Noise Level at 3 Ft: 74 dBAWeight (Total dry weight without accessories): 167 lbs.Weight (Ducts): 27 lbs. eachDimensions: 53.2 L x 23.8 W x 32.3 H inDimensions (Ducts): 12 in D X 15 ft LFuel Types: JP8, DieselSAFETY PROTECTION: Thermostatic Safety Switch (TSS): When the heater is turned off, the TSS assures that the fan continues to run until the surface temperature of the combustion chamber drops, assuring a safe restartFan Pressure Switch: When the fan stops working, this device disables ignition and cuts fuel supplySafety CO Switch: Upon detecting 100 ppm of CO, the fuel supply and ignition are disabledFlame Detector Sensor: When flame is extinguished, the fuel pump is deactivated and heater is shut offOverheat Safety Thermostat: When the heated air exceeds 250°F, the fuel supply and ignition are disabled