Heat.net

Heat.net Store Home


SIMATE Car Plug Heater 110v 1000w Convection Heaters Small Car Engine Heaters For Sale


SIMATE Car Plug Heater 110v 1000w Convection Heaters Small Car Engine Heaters
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Buy Now

SIMATE Car Plug Heater 110v 1000w Convection Heaters Small Car Engine Heaters :
$135.58

SIMATE Car Plug Heater 110v 1000w Convection Heaters Small Car Engine Heaters
Q: What car can use the engine preheater?

A: All cars equipped with the cooling system can be used.

Q:For my car, how should I choose the heater.

A:You can select a heater according to the size of the engine nacelle. If space is relatively large, then, various types of heaters can select. If there is not enough space, then, you can only choose S-8000 or S-8003A.

Q:Heating generally how long cars can easily start?

A:Depending on the condition of each car, the heating time there will be differences. When the installation is complete, you can test of time, you can know how long it needs to be heated.

Q:Why heater in the course will be very hot?

A:Because the installation, the presence of air in the engine cooling system piping. Solution: Remove the heater, reinstall it.

Q:Why after electricity, heating a slight shock, but the shell temperature is not high?

A:This is the normal phenomenon.

Q:When the heater is energized, the circuit breaker tripped. Why is that?

A:Heater electrical failure exists. Please contact the seller for a replacement.

Q:What is the difference between the various heater?

A:In addition to different power, they do not make any difference.


Brand: SIMATEItem No.: s-8005Rated power: 1000wRated voltage: 110vSize:9.4in*4.7in*3.5inWeight: 1.5 kgProduction capacity: 3000 sets per month

Material: Aluminum housing, ceramic thermostat(silver alloy contact), heating pipe made of copper, Teflon wire, built-in pump.
* installation method:

Engine preheater is installed below the tank cover 20 cm to 40 cm. Disconnect the return pipe heater, return pipe becomes the cut-off, let preheater inlet on the engine side of the pipe, the pipe on one side of the outlet of the preheater received a warm wind, is the water pump engine into the preheater, after preheater heating to warm wind to go back to the engine, and engine water circulation direction is opposite to install figure 2 steps (see instructions) is shown in figure 1 van recommended installation method. Remember to press the exhaust ah, do not exhaust gas leads to donate, high temperature water tank, heater will be dry, must exhaust. Oil (installed to start the car boom, open the tank cover, then will see bubble or antifreeze, fangdongye try to fill up, repeatedly until can\'t add antifreeze, the next day to see fangdongye, less often need to repeat the day job, touch antifreeze through piping hot means exhaust lined up.) Please go to the formal experienced repair factory installed.
* Engine preheater heating time: preheater is out of the car before heating, heating time normal winter is 20 to 30 minutes to reach its launch vehicle temperature is around 30 degrees, the heating time have weather, models such as a variety of reasons, the weather is cold, water tank, the heating time is long, in different heating time is different, after several heating can for themselves the vehicle\'s heating time, experience judgment according to the heating time, avoid heating for a long time. Don\'t long time heating, thermostats always start, stop the affect of life, can\'t misuse of electrical components have limit has been heating the temperature control is out of order. After shipment on installation instructions and the matters needing attention, is helpful to use Shipment.
Buy Now

Other Related Items:



Related Items:
Warning: Invalid argument supplied for foreach() in /home/heatnet/public_html/store/relateditems.php on line 72