 |
Perfect tool for my Hornady Lock N Load AP press. Fits the dies perfect and makes all adjustments super easy. No more wrenches or crescent wrenches needed for adjusting or removing dies. Great tool for reloading!
Verified purchase: Yes | Condition: New
I got the item very promptly and fast. After unpackaging it I noticed it looked exactly like it was supposed to. I went to use it on my 6.5 Creedmoor hornaday dies. It did not fit I then tried it on my 308 dyes it did not fit I then tried it on my 556 dies it did not fit I then tried it on my 9 mm dies it did not fit. I have more dies but I gave up at that point. The ranch itself to tighten and loosen the dyes at the butt end of it is just too small to fit over the actual dies to lock or unlock them. I had to take out my Dremel and sand about one 1/8th of an inch off the whole inside of it. If I knew that was going to be the case I would have just saved my $25 a.
Verified purchase: Yes | Condition: New
Over all this has been a waste of money . I purchased this to add to my reloading equipment on the bench but when I tried to use on Hornady and other companies dies it fit very few if any? Here a tip put a 8 inch adjustable wrench on your bench it pretty much covers all sizes and works
Verified purchase: Yes | Condition: New
The best use of this wrench is to keep the shell plate from turning when installing or removing. This is a handy wrench - it should be included with every new Lock - N - Load press!
Verified purchase: Yes | Condition: New
this maker makes the best products,.super quality the best customer awareness. product works as I needed.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Dies
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Dies
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
