Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Compressors
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Compressors
Cheap and not good. I was hoping to use this for replacement of centrifugal fan on 2hp DC motor. Did not work out due to dish back and strange bore design. Cheap spindly plastic and can't be re-bored to fit - don't bother unless the bore is exactly the size you need, and even then, there is nothing to hold this in place. I ended up buying a small pulley and making my own centrifugal fan after trying multiple versions of cheap Chinese junk fans like this. Making my own was a total pain but in the end worked out beautifully. Why does no one make a decent cheap but food little centrifugal fan?
Verified purchase: Yes | Condition: New
Took a long time to get here. But it bolted right on worked great, for 11 months, then exploded apart! Installed 7/19 broke 6/2020 I am working on a replacement and it won’t be this cheap plastic one.
Verified purchase: Yes | Condition: New
The motor fan is of reasonable quality; however, the inner diameter was undersize. The inner diameter measured 13.5mm, which required some work to fit the motor shaft.
Verified purchase: Yes | Condition: New
Works ok. Cheap price. Spend a few minutes trimming the flash off before installing. May need to use a spacer (washers, etc.) behind fan to keep it from hitting parts of motor on some compressors.
Verified purchase: Yes | Condition: New
Because the inner diameter of the plastic fan does not fit snug and is made for a metal shaft? The slack fit causes premature ware.... metal would be far superior and I wouldn't mind paying more for it.
Verified purchase: Yes | Condition: New