Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Controls & Circuit Boards
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Controls & Circuit Boards
After installation control board worked for two or three heating cycles, then started sending false diagnostic fault codes and the furnace would not run. Several hours of troubleshooting pointed to the control board. Replaced it with another new control board from bluestang5/North American HVAC with the same results: furnace worked for two heating cycles, then the control board started sending false diagnostic fault codes. Just to be certain, I replaced the components that the fault codes were indicating as bad (flame sensor and pressure switch, although both tested as good components). One emergency service call later, another new OEM control board install, and the furnace has been working fine for over a week. Interesting to note that the control boards supplied by North American HVAC look just like the original failed unit in my York furnace, and not like the one pictured in their listing, while the third control board from a different local source looks like the one pictured in their listing. So while the pictured control board may in fact be the “Upgraded” control board as stated in bluestang5’s listing, perhaps they are actually selling and shipping older defective units.Read full review
Verified purchase: No
Identical replacement for the circuit board in my furnace. Solved the problem that the exhaust fan relay was stuck in the on position. Easy to install if you record where all the existing wire go.
Verified purchase: Yes | Condition: New
Great OEM part!!! Plug and play!!! Easy do it yourself. I was quoted $830 from a local Heating and AC service company for the part only. Did it myself for $95. Took about 30 minutes and I saved $725 plus dollars. YouTube show video's on how to do if you need help.
Verified purchase: Yes | Condition: New
I’ve been replacing this circuit board about every year for the last 7 years. It will send false blink codes. I will get my meter and before I thought it was this or that part.....then after replacing a certain part it will send same code. I’ll check voltage out of the plug and it won’t send it....therefore putting out a blink code. So I’ve really replaced everything else in my furnace because I’ve believed it was. But seems I need to replace this damn thing every year. They really need a better upgraded circuit board
Verified purchase: No
Working fine; easy installation.
Verified purchase: Yes | Condition: New