I bought this Bullet Puller along with the .38 and .44 Collets when I started reloading center fire cartridges. Since I am new to reloading, I wanted to be able to undo any mistakes that might happen. I load .357 Magnum, .38 Special, .44 Magnum and .44 Special. While switching between these cartridges I have forgotten to readjust the seating depth on my bullet seating die. After completing a few cartridges, I checked the OAL and found that it was too short. So, I had to pull the bullets and readjust the seating depth. This RCBS Bullet Puller along with the correct Collet worked perfectly. It beats the heck out of one of those "Whak-a-mo" plastic Bullet Pullers.
Verified purchase: Yes | Condition: New
I bought this bullet puller, plus a .35cal collet to pull 9mm bullets, and it will not pull them at all, no matter how hard I try or how many times I try on the same bullet. It just slide off of the bullet that is still in the case. I did have a few that were barely seated in the case at all, and it pulled them, but none of my fully seated bullets wold pull. I don't like to leave negative reviews, but for potential future buyer's sake, I have to be honest about this one.
Verified purchase: Yes | Condition: Pre-owned
Can't go wrong with most RCBS products. This tool does what it was designed to do, pull a bullet from a cartridge without damage. The only other thing needed is the correct sized collet.
Verified purchase: Yes | Condition: Pre-owned
I needed a bullet puller so i could pull about 60 rounds which had the wrong powder charge. I looked at all of the pullers on the market and chose the RCBS. It seemed to be the most well constructed and easy to use. When I got the puller I was pleased with the construction. I did have a problem pulling my 60 rounds as I had cast bullets (.45acp 230 round nose), these bullets didn't have enough flat surface for the collett (which I purchased separately) to grab. Fortunately I have access to a lathe and I made a custom collett with a internal lip on the bottom and it worked like a charm, I pulled all 60 rounds in just a few minutes. Great puller.
Verified purchase: Yes | Condition: New
This thing is a lifesaver! I had 200 9mm bullets that I had loaded a little too hot and wasn't satisfied with. Have used my kinetic hammer puller before, but dreaded the tedious, messy process that goes with it. Fitted this puller with the 9.3 mm collet and mounted on an extra press. I was amazed and thrilled at the ease of pulling the bullets. Pulled all 200 in less than an hour and recovered the powder. No damage to the bullets (124 grain Speer GDHP). I will be getting collets for some of my other calibers and saying good-bye to the dreaded hammer (kinetic) puller!
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Presses & Accessories
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Presses & Accessories