This unit replaced an existing White-Rodgers valve that had been in place for at least 25 years. If I get anything close to that with this new valve, I will be very pleased indeed! The replacement process was very simple as this valve was fit into the existing brass fitting and no cutting/soldering was needed. The valve was a little different that the one it was replacing as far as wiring but the included instructions for that part of the process were very complete and easily followed.
Verified purchase: Yes | Condition: New
The only time I've had to replace these valves is if they were installed upside down. Follow directions and position the motor on top preferably or at least on its side. If motor is on bottom then any seepage or condensation will fall into motor. Also I prefer these because of the screw terminals rather than the push in type. I don't like anything with push in connection.
Verified purchase: Yes | Condition: New
The item was new from old stock worked great, and was very reasonably priced. I Recommend. JP
Verified purchase: Yes | Condition: Pre-owned
My old valve lasted 25 years. Seems to be a perfect match. Should get 25 years out of this one.
Verified purchase: Yes | Condition: Pre-owned
Have gotten good performance from this product. Resonably priced.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in HVAC & Refrigeration: Controls & Circuit Boards
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on HVAC & Refrigeration: Controls & Circuit Boards