When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Product Description advertisement signs backlightChannel letters backlight store front lightAdvertisement light box backlight & decorationsignIdeal replacement of incandescent and fluorescent lightsLOGO advertising billboard,exposed luminous charactersSuitable for boat cabin & deck lighting,stair, kitchen,courtesy,caravan,garden etc.Note :-20pcs led module each string, they can also be cut off on customer's requirement,be sure you cut the connect line between the strip.-The controller is optional, but the battery is not included.-The power supply is optional, but we we do not take responsibility for the installation,please let the profession man to install.Module Specifications:Type: 6 LED 5054 moduleMaterial: PVC PlasticLED Quantity: 6pcs each stripStandard Cascade: 20 strip one setBeam angle: 120 degreeWaterproof level: IP65Working Voltage: DC 12VPower: 0.25W / each ledDimension: 76*10*5mm / 2.99 * 0.39 * 0.20inch (each 6 led strip)Total length of each module with extension wire: 3m / 10ftOptional color: White, Warm White, Red, Green, Blue, YellowLuminous Flux: 780-900lm/20pcsWorking Temperature: -20~50℃
Package included:1 x LED 5054 module (20 strip one set)(remote controller and power supply is optional)Description of the connection between modules:
1 :Find the end of the wire, cut a length of cover about 5cm (do not cut the copper wire, only cut the cover)
2 : Connect two strip light , make sure the copper wire are fully contact to each other. (please confirm the negative and positive is right)
3 : Use the insulating tape surrounding the connecting position to prevent the electric leakage
The Modle Kits Connection:
Step 1: remove the remote battery insulation film, check the remote batter is connected.
Step 2: Connect the LED and mini DC adapter with a screwdriver, attention to positive and negative pole.
Step 3: Separate LED strip. Connect the remote and plug. Finish! Good job.
powered by
