When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
AMMO PICTURED IS NOT INCLUDED AND NOT PART OF THE SALE
New design for 2024! From the same people that designed and sell the “Straight Six” and the “Sixer” loaders for revolvers. The Speed Six side saddle fits the Mossberg 590, 500, 88, Shockwave, Remington 870 and any shotgun with a flat side receiver.
I am going to tell you right now. We have designed and produced the best stick on, receiver mounted side saddle you can buy. Made with the highest quality material and ships with the best 3M brand VHB “Very High Bond” double sided tape you can buy.
Low profile design does NOT cover or block access to receiver pins!
Universal side saddle. Made from rubberized, flexible, elastic, thermoformed polyurethane. This side saddle has been designed to provide just enough tension to secure your shells “brass down” but allow them to be easily removed for quick loading. Shells hold tight when shooting.
You can leave shells in his side saddle indefinitely. Years. The rubberized material we use does not lose it’s shape. The tension on the shells does not loosen over time like it does with fabric elastic side saddles. Perfect for a home defense shotgun stored under a bed or in a closet.
Highest quality 3M VHB tape. This is NOT cheap tape from a hardware store. This tape attaches securely to your receiver. VHB tape withstands temps up to 300 degrees. Oil, water and chemical resistant. The best part? If you want to remove it, it will come off your receiver without leaving a sticky mess.
Order includes…
- 1 x Speed Six flexible side saddle
- 3M VHB tape - already prepped and attached to the side saddle
- Alcohol prep pad to clean your receiver
To install the Speed Six side saddle on your shotgun…
- Figure out where you want to mount it.
- Use the included isopropyl alcohol pad to wipe your receiver thoroughly
- Allow the alcohol to fully dry- or use a CLEAN paper towel to dry the receiver
- ONCE THE TAPE TOUCHES THE RECEIVER IT CANNOT BE RE-POSITIONED! NO DO-OVERS!!
- Peel off the VHB tape backing
- Hold the side saddle over the area you plan to mount it and line it up.
- Once you know where to place it. Press the side saddle to the receiver and press down firmly.
- Ready to go! Full strength bod occurs after 24 hours
