When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
1981 Chevrolet Corvette Roller
*Sold For Parts Or To Rebuild*
sale!!
Clean Nevada TitleSolid High Desert VehicleComplete Frame, Suspension & Brake SystemDana 44 Rear Axle 2.87:1 Gear RatioReplacement Composite Mono-leaf RearReplacement Emergency Brake CablesKYB Gas-A-Just Shocks Front & RearDrilled Rotors Front & RearReplacement Delco Moraine Brake Calipers Front & RearReplacement Brake Booster & Master CylinderSteering Box & Steering Hydraulic Ram AssistSteering Pitman Arm, Center Link, Tie Rod AssembliesOEM GM 15x8 Aluminum WheelsOEM Urethane Bumpers Front & RearFiberglass Inner Bumper Reinforcement Front & RearFront Crash Bar Steel SubframeOEM Fiberglass Hood (No Hinges/Latches)Replacement Gas Tank & Sending UnitNo Engine/TransmissionOriginally 5.7L 350ci Engine/Automatic TransmissionNo InteriorNo Steering ColumnNo Glass (Windshield Intact But Cracked)No Door InternalsNo T-TopsNo Wiring*Vin Tag Intact (Pictured)*Trim Tag Intact (Pictured)
Built In St. Louis, Missouri GM Assembly PlantFactory Red Exterior Car With Charcoal Black Interior
This vintage 1981 Chevrolet Corvette was used as a donor vehicle to build another C3 Corvette. This is a solid Northern Nevada, high desert vehicle with a solid bird cage, floor pans and frame. No signs of any structural frame damage or accidents. The front urethane bumper shows a repair on the driver side near the headlight opening. The complete suspension and brake system was replaced by a previous owner in approximately 2014, unknown mileage on these parts. This included, front upper and lower ball joints, front upper and lower control arm bushings, front and rear rotors, calipers and brake pads, brake booster & master cylinder, front and rear KYB shocks, rear composite mono-leaf spring with 300lb rating and end links with bushings, rear batwing bushings, other associated bearings, races and wheel hub assemblies. The body shell exterior is complete but showing paint checking and fiberglass threads in multiple areas. This would make a great rolling chassis for your build, parts car for your current build or solid base for a complete restoration project, road race car, drag car, drift car, etc.!
There is a non-refundable $500 deposit to be payed within 24 hours of sale end. This is a sale, offer to win!Remaining balance to be paid by secure payment, bank transfer or cash on pickup. Buyer is responsible for pickup or transport to their location. We will not arrange transport or deliver this vehicle. There is no warranty intended or implied. This is an AS-IS sale, for a non-running vehicle, being sold for parts or rebuild ONLY!
Located in Dayton, Nevada 89403
