When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
This extractor was machined with a wire EDM from 4140 high strength steel. The machining and design time is the largest expense on this.
These beautiful little rifles are worth restoring, with a broken extractor they are of little value.
This was an early design where the extractors were not incorporated into the bolt. They’re under the bolt and in the slot in the receiver. 
Please review the pictures and make sure this is the type of extractor that will fit your gun. Installation by a competent gunsmith recommended. The bolt in the picture is not included.
Currently not accepting orders from California due to pending legislation.
This is not a firearm as follows all guidelines as found in the firearms and accessory policies. 

There are other rifles that use this type of extractor. The C.I.L model 111 was marketed in Canada.
