Sound Storm SSL EV2.1000 2-Channel Car Audio Amplifier 1000w Class A/B Amp For Sale

Sound Storm SSL EV2.1000 2-Channel Car Audio Amplifier 1000w Class A/B Amp

Condition: BRAND NEW IN ORIGINAL PACKAGING

Warranty: 1 YEAR AUDIOSAVINGS

Key Features:

2 Ohm Stable
The lowest impedance accepted by this amplifier is 2 ohms. Amplifiers that are 2 ohms stable produce more power resulting in more volume. This amp can comfortably power speakers or subwoofers with all channel(s) being used at a load of 2 ohms.Bridgeable
Bridging an amplifier means to combine channels of a multi-channel amplifier to get more power or flexibility out of it. For instance, on a 4 channel amp, channels 1 and 2 could be used normally for your speakers, and channels 3 and 4 can be bridged for more power to a single subwoofer. A 2 channel amp can also be bridged to power a single subwoofer.Class A/B
Class A/B amplifiers have long been known for their ability to produce great quality sound while performing more efficiently than pure Class A amplifiers. We have developed a specific linear circuitry that further reduces distortion while increasing both sound quality and power output.High and Low Level Inputs
An amplifier with both high-level and low-level inputs provides flexibility by allowing you to build an audio system using virtually any standard factory or aftermarket source unit. High-level (speaker level) inputs accept the signal from the speakers, while low-level (RCA) inputs accept the signal from the pre-amp outputs of the source unit.MOSFET
MOSFET stands for Metal Oxide Semiconductor Field-Effect Transistor. MOSFETs are used either as a switch or to amplify a signal. MOSFETs are superior to other FETs, because they require less current to operate, which makes them better suited for car audio.Protection
If the amplifier gets too hot, the thermal protection circuit turns the amp off and allows the amp to cool down before turning it back on. If a speaker fails causing an electrical short, the protection circuit will automatically cut the output and remain in that state until the short is resolved. These safety features give you peace of mind knowing the amplifier is constantly monitoring conditions to protect itself.Subwoofer Level Control
The ability to boost or attenuate the sub level when an amp and subwoofer are connected to the subwoofer pre-amp output.Switchable Input Sensitivity
Switchable Input Sensitivity gives you the freedom to connect the amp to any standard source unit and have peace of mind it will be within range to properly match the output of the source unit allowing you to use the volume controls on your source unit the way it was designed.Variable Bass Boost
Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it.Variable Gain Control
Variable Gain Control lets you balance the amps output with the speakers or subs the amp is driving. To much gain will lead to distortion and to little will lead to clipping.Variable High Pass Filter
Variable high-pass filter gives you control over the frequencies that pass through to the full range speakers.Variable Low Pass Filter
Variable low-pass filter gives you control over the frequencies that pass through to the subwoofer.

Features:

• MODEL 1000W High Output 2 Channel Amplifier

• Up to 375 W X 2 RMS @ 2 ohm
• Up to 188 W X 2 RMS @ 4 ohm
• Up to 750 W X 1 RMS Bridged @ 4 ohm

• Full Range, Class A/B, MOSFET Power Supply
• High and Low Level Inputs,
• Variable High Pass Crossover, Variable Low Pass Crossover, Variable Bass Boost
• Include Remote Subwoofer Control
• Dimensions: 9.5\" L x 10\" W x 2.25\" Specs
  • Channel Configuration: 2/1 Channel
  • Power Supply Type: MOSFET Power Supply
  • Amp Topology: Full Range, Class A/B

  Performance Specs

  • Total Power Output: 1000 Watts
  • Peak Power @ 2 Ω: 500 Watts x 2
  • Bridged Power @ 4 Ω: 1000 Watts x 1
  • RMS Power @ 4 Ω: 188 Watts x 2
  • Speaker Impedance: 2 to 8 Ω
  • T.H.D. (Total Harmonic Distortion): 0.01 %
  • Channel Separation ≥: 90 dB
  • S/N Ratio (A-Weighted): 103 dB
  • Frequency Response: 9 Hz to 50 kHz ±1 dB

  Connections, Controls, and Processing

  • RCA Inputs: 2 Channel
  • High Level Inputs
  • Low Pass Filter: 50 Hz to 250 Hz
  • High-Pass Filter: Variable 50 Hz Hz to 250 Hz
  • Bass Boost: Variable 0 to 18 dB
  • Subwoofer Level Control
  • Input Sensitivity Switch
  • Thermal/Overload/Short
  • Width: 10\"
  • Height: 2.25\"
  • Length: 9.5\"
  Return PolicyAudioSavings Return Policy:

  At Audiosavings, we strongly believe in customer satisfaction and therefore offer free return shipping within 30 days of purchase on all items returned to us within the continental USA.

  Prior to returning merchandise, contact us and we will give you a return authorization # and a return label.

  You may return this item for a refund within 30 DAYS of purchase.

  Warranty Repair/Exchange Period: 1 YEAR

  If your item is defective or you want to return it for any reason within the first 30 days of when it was delivered to you; you have the following options:

  • We will send you a pre-paid shipping label to replace the item for a brand new one.
  • We will send you a pre-paid shipping label to exchange the item for another item of your choice. If the item you chose is more or less money we will work out the price difference with you.
  • If you are returning a working item in used condition for a refund there will be a 20% used item fee deducted from your refund. All replacements and exchanges are free.
  Replacement/Processing Time:

  Your replacement or refund will process within 3-5 business days of when we receive the item.

  Please note items with physical damage un-related to shipping are not covered under warranty. Registered software cannot be returned.

  You MUST notify us within 48 hours if you receive an item that was damaged during shipping.

  Process for returning items

  Please email us with your user ID, Item code / model #, Condition of the item, and the reason for your return. Please also indicate whether you would like a replacement, an exchange, or a refund. We will supply you with a reference number (RMA #) to put on the package which will ensure quick processing of your return. All returns require a RMA# to be returned back to our facility.

  Item Code: EV2.1000

  Home / About Us / Contact Us / Returns / FAQ\'sCopyright © 2016 Audio Savings, All rights reserved. | Template Design