When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Vertical Base Tilt-Over Antenna Mount.100 Percent Made in Evansville, Indiana USA. This new and improved design is similar to the MFJ-1903 and the Intellitron AB-1612This is the original RRS-1903 ! Designed and individually made by Raymond Sult N9KGC. Please be aware there is a Chinese clone/copy-cat available here on . Remember, I can customize / modify yours if you need. You can contact me directly. The Chinese clone will have no customer support.
Antenna Tilt Mount for vertical base antennas. Stronger and much improved over the MFJ-1903 and the Intellitron AB-1612
Individually made (not mass produced) from 6061 four inch aluminum channel and 3/16 mild steel that is used to make the outer channel.
There is No Flex with this new stronger design ! Pivots / hinges on a large robust 7/16 pin / bolt rather than the two small 5/16 bolts that are used on the MFJ-1903 and Intellitron AB-1612 models. Is secured in place when in the "Up" position by two bolts that thread into the channel rather than using nuts and bolts as the MFJ-903 did. This allows for easier securing without having to reach inside the channel to hold the nuts with a wrench.
This tilt mount comes with four (4) U-bolts. Two for the "Antenna" tilt-over side and two for the stationary side. Included U-bolts work with mast or pipe up to two (2.0) inch outside diameter. (if you need holes for larger U-bolts contact me)
* I also have an ALL STEEL version available at a reduced price here on and my on site.
(The recent increase in the cost of aluminum has driven up the price of this aluminum and steel version)
Ships FREE in the USA ! Made in the USA
Selling here on since 1999.Yes, 27 years !
Check My 100 Percent Positive response !
* Please allow four (4) business days for this item to be fabricated and leave my shop. This item is fabricated after it is ordered.
If you need a custom or modified version of this item (or ANY item I make) please contact me with your request. (Different size U-Bolts etc.)
73, from N9KGC
_
